Start 3D printed flying
That's amazing
3D Printed
As usually, this is fully 3D printed airframe. You'll need only 8mm Carbon tube as a spar. We've had to use it to make wings removable and easy to transport
FPV and Flight Controller ready
There are very few FPV friendly 3D printed planes on the market. And we are here to change it - your FPV and Flight Controller gear may be installed in a right place
LED lights
For those who would like to have nice look - there's a special LED-ready Fuselage part
See more
Technical Specificaiton
Read the MANUAL for recommended setup
Wing Span
1000 mm
FPV
Caddx Vista and Air Unit mount
20x20 analog VTX, antenna and camera mount
Pan servo
20x20 analog VTX, antenna and camera mount
Pan servo
Efficiency
You'll be amazed of how efficient the wing is
Take off weight
550 g of printed parts and
up to 1,2 kg with 4s1p 21700 battery pack
up to 1,2 kg with 4s1p 21700 battery pack
Maximum speed
We do not recommend exceeding 250 km/h
Powerplant
2807 1500-1700 motor
7042 prop and 40A ESC for 4S
7042 prop and 40A ESC for 4S
Battery
Tested with:
6s 1350 LiPo
4s1p 21700 Li-Ion pack
4s2p 18650 Li-Ion pack
6s1p 21700 Li-Ion pack
6s 1350 LiPo
4s1p 21700 Li-Ion pack
4s2p 18650 Li-Ion pack
6s1p 21700 Li-Ion pack
Video recording
Recommend using Insta 360Go 2 or similar
Images credits: wikimedia commons | wikimedia
Фотографии и тексты использованы для демонстрации возможностей шаблона сайта, пожалуйста, не используйте их в коммерческих целях.